| Electrical | Available in 3500K, 4000K, and 5000K color temperatures, 80 CRI. 120-277VAC or 347VAC, 50/60Hz electrical input with high power factor electronic, constant-current driver (>.90 PF). Standard 0-10V dimming with 1-100% range; maximum driver source of 200 μA. Optional embedded microwave motion sensor (MS) has factory default settings of 20 minute time out, dims down to 30%.
|
|---|
| Eyelid | High-impact resistant, UV-stabilized injection molded opaque dark bronze polycarbonate. See Ordering Information for optional finishes to match housing. |
|---|
| Gasket | Die-cut closed cell neoprene gasket seals die-cast housing to mounting surface. Refractor inset into housing and sealed to integral ledge with one “O” ring closed cell silicone gasket. |
|---|
| Hardware | Four captive stainless steel Torx® with center pin fasteners secure refractor/eyelid to housing. Shoulder fastener design and washer prevent lens/eyelid stress due to over torquing. |
|---|
| Housing | One-piece heavy duty die-cast, low-copper aluminum housing. Housing flange interlocks around lens producing maximum moisture deflection and resistance to prying. Housing provided with four standoff mounting holes. One 3/4" IPS tapped hole on back of housing. Standard housing in dark bronze TGIC polyester powder coat – 5-stage pre-treatment. Two 3/4" IPS tapped and plugged holes on top and bottom of housing – see Cross Section/Details.
|
|---|
| Installation | Standard four-point mounting required for Peace of Mind Guarantee®.
|
|---|
| Lens | One-piece wraparound lens (UV-stabilized, high impact, virgin injection molded polycarbonate). Smooth exterior, prismatic interior. Nominal thickness: 0.125". |
|---|
| Listings | Luminaire is certified to UL Standards by Intertek Testing Laboratory for Wet Location. |
|---|
| Photometrics | Photometry tested to the IESNA LM-79-08 standard by an ILAC/ISO17025 accredited laboratory. For additional photometric data, please go to www.kenall.com. |
|---|
| Reflector | High reflectance painted aluminum.
|
|---|
| Warranty | One (1) year warranty against defects in materials and workmanship. Five (5) year warranty on LED lamps and driver for defects resulting in a fixture lumen depreciation of 30% or greater. |
|---|