| Doorframe | 18-gauge CRS. One-piece inset construction with welded corners. White TGIC polyester powder coat – 5-stage pre-treatment. Salt spray test: 1,000 hours; Reflectance: 92%. Optional 20 gauge type 304 stainless steel with 4B brushed finish. Lens frame secured to housing with continuous hinge and 3 tamper-resistant stainless steel Torx® with center pin fasteners. |
|---|
| Electrical |
(Single- and Dual-Mode ICT) Serviceable mid-power white and 405nm Indigo LED array. Available 3200K, 3700K and 4300K color temperatures with 3-step MacAdam variation allowance. Minimum 82 CRI standard. 120-277VAC and 347VAC electrical input with serviceable high power factor electronic, constant-current drivers (<10% THD, >0.90 PF). Minimum 85% driver efficiency. Standard 0-10V dimming with 1-100% range and dim-to-dark capabilities. 495μA maximum source current. Single-Mode ICT provides a single, white disinfection operational mode. Dual-Mode ICT provides two operational modes based on room occupancy. White Disinfection Mode is a white LED array for ambient lighting plus a simultaneous low-power 405nm LED array for low-level, continuous and safe environmental disinfection. Indigo Disinfection Mode is a higher-level 405nm array for continuous safe environmental disinfection during periods of room vacancy. The operational mode is determined via internal low-voltage device based upon the input signal provided by an external control device/system. Luminaire dimming is overridden in this operational state. Refer to the Kenall Dual-Mode ICT Control Application Guide for further description.
|
|---|
| Housing | 20-gauge CRS. Hole-free, one-piece, seam-welded construction.18-gauge housing flange with mitered and welded corners. White TGIC polyester powder coat finish – 5-step pretreatment. Salt spray test: 1,000 hours; Reflectance: 92%. |
|---|
| Installation | Adjustable swing-out mounting brackets standard. Suitable installation into -30˚C to 40˚C ambient environments, unless otherwise noted. |
|---|
| Listings | Luminaire is certified to UL standards by Intertek Testing Laboratory for non-IC and Wet Location installations. ETL certified IP65 per IEC60598. |
|---|
| Optics | Diffused acrylic inner lens with 0.25" clear polycarbonate outer lens. Lens sealed to doorframe with silicone sealant and secured with continuous lens retention system. |
|---|
| Photometrics | Photometry tested to the IESNA LM-79-08 standard. For additional photometric data, please go to www.kenall.com. |
|---|
| Warranty | Limited five (5) year warranty. Peace of Mind Guarantee™. |
|---|